Troubleshooting: Hardware 6
External effects aren’t working.
Effects processor is not plugged in or turned on.
Aux outputs of mixer aren’t connected to inputs of processor or processor’s outputs aren’t connected to mixer’s inputs (or aux return).
Mixer’s effects return signal is too low.
Make sure unit is plugged in and turned on.
Make sure the mixer’s aux outputs are connected to the processor’s inputs and that the processor’s outputs are connected to the mixer’s aux inputs.
Turn up the output of the effects processor or turn up the mixer’s AUX RET A RETURN or EFFECTS / AUX RET B RETURN in the master section.
LED meters not working.
Computer does not see the MultiMix USB2.0.
Nothing is routed to the HDPH/CTRL RM output.
USB2.0 connection must be established.
Press the desired MIX or 2 TK button.
Unplug the USB2.0 cable and turn off the MultiMix. Turn the MultiMix back on and plug the cable back in. If this does not work, leave the MultiMix on, turn off the computer (do not use “restart” but instead actually turn off the computer) and then turn it on again.
Computer sees the MultiMix USB2.0, but no sound is received and/or transmitted.
No power.
MultiMix USB2.0 is not set |
| In the computer’s Control Panel, |
as primary sound device. |
| go to the Sounds/Multimedia |
|
| area. In the Audio section, set |
|
| the default sound recording and |
|
| playback devices to MultiMix |
|
| USB2.0. |
|
|
|
Incorrect or defective power |
| Replace with correct power |
supply. |
| supply (only use Alesis- |
|
| recommended AC output power |
|
| supply). |
45