CTX PR711FL user manual Trouble Shooting, Problem What to do

Page 15

PR711FL User’s Manual

Trouble Shooting

Notify your supervisor or contact your service personal when:

•Power cords are frayed or damaged.

•Liquid is spilled into the monitor.

•The monitor does not operate normally when operating instructions are observed.

•The monitor has been dropped or the cabinet has been damaged.

Review this list of trouble-shooting tips before contacting an authorized service center.

Problem

What to do

Power Indicator (LED) is not lit.

No Picture.

No Signal Input.

Make sure Power control is in the ON position.

Check the power cable. It must be plugged in completely.

If the Power Indicator is amber-colored your computer has sent the monitor into its Power Save mode (See "Energy Declaration.")

The video card may not be seated properly. Make sure it is fully seated in its slot.

Make sure the signal cable is connected securely to the video card or computer.

Enable "Power Save" function.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents E r ’ s M a n u a l Table of Contents CE Statement Safety InstructionsSafety Precautions FCC StatementPR711FL User’s Manual Recommendation for Optimum Performance Introduction Installation System SetupUnpacking Remove the Tilt/Swivel Base Installing the Tilt/Swivel BaseFront Panel Controls Controls and AdjustmentsOSD On-Screen Display Controls How to Make On-Screen Display OSD AdjustmentsStatus PR711FL User’s Manual Converage Contrast/Brightness Problem What to do Trouble ShootingPR711FL User’s Manual Two horizontal lines are visible on the screen Symptom TipPR711FL User’s Manual Vesa Power-Management Proposal Power Consumption 120/230 VacEnergy Declaration Specification Reference Information Connector Pin AssignmentsResolution Format Horizontal Refresh Rate Hz Frequency KHz Preset Timing Chart
Top Page Image Contents