CTX PR711FL user manual Remove the Tilt/Swivel Base, Installing the Tilt/Swivel Base

Page 8

PR711FL User’s Manual

Remove the Tilt/Swivel Base

1.Squeeze and hold the latches.

2.Pull the tilt/swivel base to the rear of the monitor and lift to remove the base.

Installing the Tilt/Swivel Base

1.Align the base with the slots on the bottom of the monitor and insert the tilt/swivel base into the slots.

2.Push the tilt/swivel base firmly toward the front of the monitor until the latches click into the locked position.

8

Image 8

Contents E r ’ s M a n u a l Table of Contents Safety Instructions Safety PrecautionsFCC Statement CE StatementPR711FL User’s Manual Recommendation for Optimum Performance Introduction Unpacking InstallationSystem Setup Installing the Tilt/Swivel Base Remove the Tilt/Swivel BaseControls and Adjustments Front Panel ControlsHow to Make On-Screen Display OSD Adjustments OSD On-Screen Display ControlsStatus PR711FL User’s Manual Converage Contrast/Brightness Trouble Shooting Problem What to doPR711FL User’s Manual Symptom Tip Two horizontal lines are visible on the screenPR711FL User’s Manual Energy Declaration Vesa Power-Management ProposalPower Consumption 120/230 Vac Specification Connector Pin Assignments Reference InformationPreset Timing Chart Resolution Format Horizontal Refresh Rate Hz Frequency KHz