CTX PR711FL user manual Symptom Tip, Two horizontal lines are visible on the screen

Page 17

PR711FL User’s Manual

Edges of display are curved inward or outward.

No Plug & Play.

Refer to "Controls and Adjustments." You need to adjust the "Side Pincushion."

Verify that the host system is Plug & Play compatible.

Check to see if Windows is installed, and the software key for the Data Display Channel (DDC) function is enabled.

Determine if original manufacturer's detachable signal cable is being used (D-Sub-15 pin only).

Our monitor is build-in FD Trinitron® CRT. This CRT is sensitive to shocks and vibrations that may occur during transportation. Following are some adjustment tips when below mentioned symptoms occur.

Symptom

Tip

Two horizontal lines are visible on the screen

This is normal characteristic of FD Trinitron® CRT.

These are damper wires, which are attached to the aperture grille and are designed to dampen and prevent shock and vibrate to the aperture grille.

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents E r ’ s M a n u a l Table of Contents Safety Precautions Safety InstructionsFCC Statement CE StatementPR711FL User’s Manual Recommendation for Optimum Performance Introduction Unpacking InstallationSystem Setup Remove the Tilt/Swivel Base Installing the Tilt/Swivel BaseFront Panel Controls Controls and AdjustmentsOSD On-Screen Display Controls How to Make On-Screen Display OSD AdjustmentsStatus PR711FL User’s Manual Converage Contrast/Brightness Problem What to do Trouble ShootingPR711FL User’s Manual Two horizontal lines are visible on the screen Symptom TipPR711FL User’s Manual Energy Declaration Vesa Power-Management ProposalPower Consumption 120/230 Vac Specification Reference Information Connector Pin AssignmentsResolution Format Horizontal Refresh Rate Hz Frequency KHz Preset Timing Chart
Top Page Image Contents