Adjusting the Speaker Volume Balance
This unit is set to the standard level before shipping from the factory. You may not need any adjustment.
However, depending on the size of the room and the placement of the speakers, you may benefit from a fine adjustment.
In this case, follow the steps below. Please use the remote control when the test tone sounds.
Note:
Do not connect the headphones.
1.Press [FUNCTION] to select the “DVD/CD” function.
2.Press [n] to stop playback completely.
3.Press [TEST] on the remote control.
The “Speaker” screen appears on the TV screen.
Speaker
0
The test tone will be heard from each speaker sequentially as follows:
TV screen | FL display | Speaker |
Front left speaker | ||
Center | CENT 0 | Center speaker |
Front right speaker | ||
Surround right speaker | ||
Surround left speaker |
3, 6
1
4
5
2
4.Press [VOLUME] + or - until the test tone becomes a comfortable level.
5.If the test tone level is not the same from each speaker, press [p] or [o] to adjust it while the speaker is activated.
The level appears on the TV screen and FL display.
Center:
If necessary, repeat this step again.
6.Press [TEST] to turn the test tone off. Note:
If no adjustments are made, the original display returns after the test tone cycles around 5 times.
Adjusting the Subwoofer Level
Note:
Do not connect the headphones.
1.Press [TRIM].
2.Press [ENTER] repeatedly to select “SUB.W 0”. Note:
Each time the button is pressed, the FL display will show the selected speaker and tone level.
3.Press [p] or [o] to adjust the level as desired. SUB.W:
Note:
If another speaker is selected, the level can also be changed as above.
4.Press [TRIM] to turn it off. Note:
If no adjustments are made, the original display returns after approximately 10 seconds.
IMPORTANT INFORMATION:
Set the delay time for your center and surround speakers. See “Setting Audio” on page E34.
1, 4
2 | 3 |