Sanyo DWM-2600 instruction manual Listening to Preset Stations, Number buttons Enter

Manual presetting

1.Tune in the station to be preset as described in “Automatic/ Manual Tuning”.

2.Press [PROGRAM/RANDOM]. “P - -” blinks.

3.While “P - -” is blinking, press [PRESET +] or [- PRESET] to select the channel to be preset.

•The number buttons on the remote control can also be used.

•In this example, the channel is “9”.

4.While it is blinking, press [ENTER].

•In this example, “103.1 MHz” FM station is preset on FM channel 9.

5. Repeat steps above to add more preset stations.

•When presetting a new station, the previous preset station is cleared.

Listening to Preset Stations

Preset tuning

1.Press [TUNE/BAND] to select FM or AM.

2.Press [PRESET +] or [- PRESET] briefly to select the desired channel.

•If using the number buttons, press the number button(s), then press [ENTER].

Preset scan tuning

1.Press [TUNE/BAND] to select FM or AM.

2.Press [PRESET +] for at least 1 second.

•The channel number appears.

•The preset stations are selected in sequence for approximately five seconds each.

3.Press [PRESET +] when the desired station has been selected. Preset scanning will stop.

When beat interference is heard

A high-pitched noise called “beat” is sometimes heard during reception of radio broadcasts.

If this occurs, while holding [n] down on the front panel, press [TEST] on the remote control to select “bc-A” or “bc-B”. Select the setting that gives the best results.

2

Number buttons

4

3

Number buttons

1

Enter

2

Changing the reception frequencies

If necessary, use the following procedure to change the reception frequencies.

1.Select the band to be changed.

2.While holding [n] down on the front panel, press [PROGRAM/ RANDOM] on the remote control.

To return the original setting, repeat steps above.

AM: 520 ~ 1710 kHz (10 kHz steps)

522 ~ 1710 kHz (9 kHz steps)

FM: 87.9 ~ 107.9 MHz (200 kHz steps)

87.5 ~ 108.0 MHz (50 kHz steps)

-E38-