Using the Device Manager
You can configure and customize the Junxion Box using the Device Manager. The Device Manager is built into the Junxion Box itself, so you don’t need to install any additional software. You can operate the Device Manager with most web browsers.
Help tips are available on each page in the Device Manager. To read a help tip for the topic at hand,
Opening the Device Manager
•Make sure you are connected to the Junxion Box.
•Open your web browser.
•Enter 192.168.2.1/admin as the URL, unless you already changed the local IP address range for the Junxion Box, in which case you must connect through the IP address you configured <LAN IP address>/admin.
•Enter a username and password when asked. The username is admin and the default password is junxion using all lowercase letters.
To prevent others from changing the Junxion Box settings, change the Device Manager password. See the Security Page topic below.
Status Page
The Status page is the first page you will see when you enter the Device Manager. This page allows you to quickly check the status of the Junxion Box.
WWAN Status. Shows “Ready” when the Junxion Box is successfully connected to a cellular data network.
Signal Strength. Indicates the signal strength of the cellular PC Card modem. The signal strength is checked once when the cellular modem first connects to the cellular network. To update the signal strength, reboot the WAN interface from the WAN page in the Device Manager.
16 | junxion box user guide |