Junxion JB-110B, JB110E manual Wan

Page 18

Connected Clients. Displays the number of LAN devices connected to the Junxion Box. You can view the list of MAC and IP addresses for any connected clients from the LAN page.

Firmware Version. Shows the version of the Junxion Platform firmware operating on the Junxion Box. Check the Update page to see if new firmware is available.

Field Commander. Displays “Active” when the Junxion Box is connected to the WAN and configured correctly for Field Commander™. To learn more about Field Commander, or to create your own secure Field Commander account, visit www. junxion.com/fieldcommander.

WAN Page

The WAN page allows you to change the wide area network (WAN) settings that determine how the Junxion Box connects to the Internet.

Each group of settings on this page has its own Apply button. After making changes to the settings in each group, you must then click Apply to save the changes.

Select Backhaul. Three WAN backhaul modes are available with the Junxion Box.

PC Card Modem is the default configuration. The Junxion Box uses the cellular PC Card modem for the WAN connection. Both Ethernet port 1 and 2 are available for clients connecting with a LAN address.

WAN Juggler allows the Junxion Box to use either the cellular modem or an Ethernet WAN link (DSL, cable, office LAN) to connect to the Internet. Either can be designated the primary WAN connection. If the primary connection drops, the Junxion Box will route traffic over the alternate connection. WAN Juggler reverts traffic back to the primary source when that connection resumes. In this configuration, Ethernet port 2 is used for the WAN connection. Port 1 is still available to LAN clients.

IP Passthrough mode will pass the cellular WAN IP address directly through to any client connected to port 2 on the Junxion Box. This may be necessary for some VPN configurations or other enterprise applications. The Junxion Box can also continue to provide LAN IP addresses to clients connected through port 1 (or Wi-Fi with the JB-110b). However WAN Juggler, DMZ, and Port Forwarding are not available and the Device Manager cannot be reached through port 2. Any client connected to port 2 must be setup with a static IP address and a gateway address that matches the WWAN

18

junxion box user guide

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Junxion Box User Guide Page Table of Contents Page Introduction What’s Included with the Junxion Box?What Else Do You Need to Get Started? Getting Going the quick version Status Lights Hardware OverviewTurning On the Junxion Box Ethernet Crossover CableJunxion Box Hardware Diagram Wi-Fi Antenna JB-110b only Power Cycle ButtonCellular PC Card Modem Slot Connecting the Junxion Box to the Internet Connecting Through a Cellular PC Card ModemSupported Cellular Card Modems Sprint Nextel Connection Charges Contacting Your Cellular CarrierConnecting a Computer to the Junxion Box Connecting Through EthernetConnecting Through Wi-Fi JB-110b only Junxion box user guide Where to Find More Help Using the Device Manager Opening the Device ManagerStatus Figure Status WAN Figure WAN Junxion box user guide Junxion box user guide Figure LAN Page JB-110b with Wi-Fi shown LAN Figure Port Forwarding Port Forwarding is unavailable if IP passthrough is enabled Port ForwardingFigure Security Page JB-110b with Wi-Fi shown Security Services Junxion box user guide Figure Services Figure Services Splash Figure Splash Figure Update Update About and Help Pages Guest User StatusResetting Your Junxion Box If You Forget Your Device Manager PasswordFrom the Device Manager Additional Support Technical Specifications WANAccessories HardwareSafety Information and Instructions Junxion box user guide Regulatory Information Limited Warranty and Liability Junxion box user guide Junxion Software License Readme Junxion box user guide Legal Disclosure
Top Page Image Contents