Monster Cable 350S warranty Do not drill holes in masonry mortar joints

2) �����

�����

Installing the PowerMount Wall Unit and Wall Mounting Plate continued

Masonry Mounting

DO NOT drill holes in masonry mortar joints.

Masonry mounting requires specialized knowledge, skills and tools. Monster highly recommends the help of a professional installer when mounting to masonry.

1)With the help of a friend, vertically position the PowerMount Wall Unit in your desired mounting location.

Using the provided level, confirm that the power unit is vertically straight.

3)Mark the centers of the top and bottom mounting holes on the power unit with a pencil. Be careful not to mark a mortar joint.

4)With your electrical drill and 1/2 in/13 mm masonry bit, pre-drill a 3 in/76.2 mm deep hole at each mark.

5)Install the supplied plastic concrete anchors in each hole. Tap into hole until fully seated.

6)Align the power unit’s mounting holes with the holes in the wall.

7)While one person holds the power unit, set the wall mounting plate inside the power unit’s recessed area. Hold both the mounting plate and power unit firmly in place.

14