Momentum Sales & Marketing MO8 manual Network Configurations, One to One Connection

Page 11

Chapter 2

Connection and Setup

 

 

Network Configurations

The following are examples of network configurations. These samples show configurations using ana- log inputs and outputs. Momentum digital input and outputs or DSP devices use the same methods for network configuration.

Using the Momentum system, the network configuration possibilities are endless. For more information on advanced configurations and support, visit www.procomomentum.com. For further support, con- tact you local dealer or Pro Co technical support.

One to One Connection

Chn 001 must be present on the network at all

!times. This unit will sync the network clock.

 

mi8 Input

Direct Copper Connection

Direct Fiber Connection

275 Meters using 62.5/125um MMF 200Mhz

CAT5E or CAT6

550 Meters using 50/125um MMF 500Mhz

No crossover required

 

100 Meters

Cross Fiber Rx/Tx

mo8 Output

Optionally, Fiber and Copper may both be connected for redundancy.

Momentum mo8 Manual

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Mo8 Warranty Table of Contents Use Extreme Caution Welcome Momentum System FeaturesMo8 Enclosure Rear Panel with Contractor Panel Rear PanelConnection and Startup PowerFiber Connection Optional Network WiringCopper Wiring Copper ConnectionOne to One Connection Network ConfigurationsStage 48 x 8 Typical Snake SystemChn=009 Adr=002 48 x8 With Split Network SystemNetwork Clock Sync SetupUsing the Control Panel Sample Rate Setting Device Before UseStart Channel Route IP AddressF1 and F2 Functions Control Panel FunctionsDescription of Functions Channel Start Route Off or Mo8 Specifications
Top Page Image Contents