Orbit II Disc-to-Disc Copier Reference Manual – Revision I
5.4 Initial Orbit II Copying System Checks:
Turn Power On by operating the switch on the external Power Supply. The system’s power on sequence will take a few seconds, but it should conclude with the display shown in the photograph below. If the Copy
If you do not see anything on the display, check the external power supply connections. Make sure the red light on the external power supply goes on when you turn on the power switch. If the light does not go on, either the AC Receptacle you used does not have power, or the external power supply may be defective. Contact Microboards Technology Technical Support.
If the display has any other message, or is unreadable, Contact Microboards Technology Technical Support.
5.5 Navigating the Orbit II Menu Tree:
This is the top level of the Orbit II operating system menu tree.
1 Line x 16 Character
Display
2 Key
Keyboard
Orbit II Display and 2 Key Control Panel
13