MicroBoards Technology II manual Loading Masters

Page 19

Orbit II Disc-to-Disc Copier Reference Manual – Revision I

singulation cycle, but there should always be at least two discs in the horizontal group.

The horizontal group should never become empty while there are discs leaning against the Stepped Guide Rod. If this happens there is a media problem. Contact Microboards Technology Technical Support for assistance.If you are running a very large duplication job (more than 50 copies of a single master) you can add discs, remove accepted discs, or remove rejected discs while the system is running.

Loading Masters:

You may use CDs, CD-Rs, or CD-RW discs as Masters. Masters are always placed in the CD Reader located in the lower right hand corner of Orbit II’s Front Panel. Because Orbit II is a CD-to-CD copier,

there must always be a master in the CD Reader during copy or compare operations. When you

press

Yes

at a

 

,

 

, or a

 

 

 

Copy CD-to-CD?

 

Copy & Compare?

 

Compare CD?

 

prompt; Orbit II’s controller will open the CD Reader for you. Load your master in the reader the same way you would load an audio CD in a CD Player.

When you are sure the master is properly loaded in the CD Reader’s tray press Yes . Orbit II’s Controller will close the Reader tray and begin the copy or compare operation you selected.

19

Image 19
Contents Orbit II Stand Alone CD Disc-to-Disc Office Copier Table of Contents Introduction Setting Up your CD-R Copying Area CD-R & CD-RW Media Recommendations CD-R Media Recommendations CD, CD-R, and CD-RW Master Considerations Orbit II Disc-to-Disc Copier Reference Manual Revision Unpacking the Orbit II and verifying shipment contents Installation & SetupInspecting the shipment for Damage Installing the Orbit Installing the Orbit II Installing the Orbit II Navigating the Orbit II Menu Tree Initial Orbit II Copying System ChecksKey #2 the No key Key #1 the Yes keyBurn CD? Must be set to YES to Copy CD+G Karaoke discsBurn CD? Must be set to YES to run Copy and Compare Navigating the Orbit II Menu TreeAsk Quantity? to Loading CD-Rs Loading & Unloading CD-RsFirst 5 or 6 CD-Rs Yes At a Or a Copy CD-to-CD? Copy & Compare? Compare CD? Loading MastersUnloading Accepted CD-Rs Unloading Masters Quantity? CD-R Handling TestsCopy CD-to-CD? Copy & Compare? Compare CD? Turn Burn CD? on Writer and Reader TestCopympare& CD? Yes Quantity? Copy CD-to-CD? OrCopy & Compare?Copy CD-to-CD? Basic Orbit II OperationsCopy CD-to-CD? Copy & Compare? Copy and Compare?Copy CD+G Compare CD?Special Notes Advanced Orbit II OperationMaintenance Routine Maintenance Troubleshooting Prior to Calling for Assistance Technical Support Telephone # References WarrantyRegulatory Agency Approvals Specifications Altitude EnvironmentVibration ShockCopy CD+G Karaoke discs DC Power Attachment B Orbit II Functional SchematicAC Power Attachment C Orbit II Error Messages Attachment D What is BurnProof? Orbit II Disc-to-Disc Copier Reference Manual Revision