MicroBoards Technology manual Attachment C Orbit II Error Messages

Page 37

 

 

Orbit II Disc-to-Disc Copier Reference Manual – Revision I

 

 

Attachment C Orbit II Error Messages

Error Message:

 

Problem Description:

 

!! Bad Copy!!

The copy CD is bad and will be rejected. This message may briefly appear during any of Orbit II’s operating modes.

!!ERROR!! No CD Reader!

This message would appear during a power on self-test if the copy controller did not locate a compatible CD Reader.

 

 

Contact Microboards Technology Technical Support.

!!ERROR!! No CD-R Drives!

This message would appear during a power on self-test if the copy controller did not locate a compatible CD-R/CD-RW

 

 

Writer. Contact Microboards Technology Technical Support.

!!ERROR!! Disc is Blank!

This message would appear at the start of a copy or compare job if the copy controller could not read the disc that is in the

 

 

CD Reader. Check your master CD, CD-R, or CD-RW discs, and try again. If this message persists, contact Microboards

 

 

Technology Technical Support.

Setup Error

The user Setup file has been corrupted. Turn the external power supply OFF, and leave it OFF for a few moments. When

 

 

you turn your Orbit II System back ON it will reset the user Setup file to the factory default values of Burn CD? Yes and

 

 

48x Write? Yes. If you are not using these default settings, make the appropriate System Setup? changes before you use

 

 

your Orbit II System.

!!WARNING!! Copier

Your Orbit II System Setup has been changed to Burn CD? No. If you want to proceed with the operation you selected

is in SIMULATE mode

press the Yes key. If you do not want to proceed in simulate mode, press the No key and change the System Setup?.

37

Image 37
Contents Orbit II Stand Alone CD Disc-to-Disc Office Copier Table of Contents Introduction Setting Up your CD-R Copying Area CD-R & CD-RW Media Recommendations CD-R Media Recommendations CD, CD-R, and CD-RW Master Considerations Orbit II Disc-to-Disc Copier Reference Manual Revision Unpacking the Orbit II and verifying shipment contents Installation & SetupInspecting the shipment for Damage Installing the Orbit Installing the Orbit II Installing the Orbit II Navigating the Orbit II Menu Tree Initial Orbit II Copying System ChecksKey #2 the No key Key #1 the Yes keyBurn CD? Must be set to YES to Copy CD+G Karaoke discsBurn CD? Must be set to YES to run Copy and Compare Navigating the Orbit II Menu TreeAsk Quantity? to Loading CD-Rs Loading & Unloading CD-RsFirst 5 or 6 CD-Rs Yes At a Or a Copy CD-to-CD? Copy & Compare? Compare CD? Loading MastersUnloading Accepted CD-Rs Unloading Masters Quantity? CD-R Handling TestsCopy CD-to-CD? Copy & Compare? Compare CD? Turn Burn CD? on Writer and Reader TestCopympare& CD? Yes Quantity? Copy CD-to-CD? OrCopy & Compare?Copy CD-to-CD? Basic Orbit II OperationsCopy CD-to-CD? Copy & Compare? Copy and Compare?Copy CD+G Compare CD?Special Notes Advanced Orbit II OperationMaintenance Routine Maintenance Troubleshooting Prior to Calling for Assistance Technical Support Telephone # References WarrantyRegulatory Agency Approvals Specifications Vibration EnvironmentShock AltitudeCopy CD+G Karaoke discs DC Power Attachment B Orbit II Functional SchematicAC Power Attachment C Orbit II Error Messages Attachment D What is BurnProof? Orbit II Disc-to-Disc Copier Reference Manual Revision