MegaVision Network Management System manual

1.Check that the current image represents an SNMP device. The “MegaVision” item should not appear within non-SNMP devices.

2.In the DOS prompt or SpectroSHELL prompt, change your working directory to

<SpecDir>\SG-Support\CsIib\GnSNMPDev directory, (<SpecDir> is a Spectrum directory) There are three ASCII files if interest there: Large.Bas, Small.Bas, The.OPR You may view/edit them using any DOS editor or the “vi” editor under SpectroSHELL. These files should contain the following string:

Script.Act(0,0,Script(“MegaVision”,0x117a7,0x1006e,0x10024,0x1027f,0x100

71,

0x110c4)) The string should appear in the end of every file before “} ” string. 3. Compare the files to the same files in the MegaVision directory..

If You Have Problems Starting MegaVision From The Spectrum

Icon Submenu:

1.In the SpectroSHELL prompt change your working directory to: <SpecDir>/SG-Support/CsScript(<SpecDir> is a Spectrum directory) These two files must be present: MegaVision and sendspec.exe

2.If these files do not exist, follow these commands to create them in that directory: cp <MegaVision Dir>/exe/sendspec.exe <SpecDir>/SG-Support/CsScript cp <MegaVision Dir>/megavisi.scr <SpecDir>/SG-Support/MegaVision

If you have problems viewing devices front panel (e.g. the sizes of the modules are not correct and you cannot see all the modules) or some data screens seem misaligned, please change these Windows Settings:

Change “Control Panel”/”Display”/”Settings”/”Font size” to “Small Fonts”.