Do not configure this adapter | Pentair BB-HCM381A, BB-HCM311A

Connecting the ScreenLogic Video & Lighting Protocol Adapter

The following describes how to connect the Video & Lighting Protocol adapter to an existing ScreenLogic system.

1.Connect the provided RJ45 (CAT5) cable to an available port (1, 2, 3, or 4) on the ScreenLogic wireless router. Connect the other end of the cable to the LAN port on the Video & Lighting Protocol adapter (see diagram on page 2).

2.Lights cable connection: Connect an RJ45 (CAT5) cable to the COM 1 port on the adapter. Connect the other end of the cable to the DB9M/RJ45 adapter. Connect the DB9M/RJ45 adapter to the RS-232 connector that is connected to the UPB Powerline Interface Module (PIM). See diagram on page 2.

3.Camera cable connection: Connect AC power plug to the video camera(s). Connect the RJ45 camera cable to port 1, 2, 3, or 4 on the ScreenLogic wireless router (see diagram on page 2).

If additional cameras are being installed, a Network Switch can be used to provide available ports. ScreenLogic supports a maximum of four cameras (see diagram on page 2).

ScreenLogic Video & Lighting Protocol Adapter Name

The Video & Lighting Protocol adapter system name is identified on the screen as:

Pentair: xx-xx-xx(where xx-xx-xx are the last six (6) digits of the unit’s serial number which can be found on a sticker on the adapter). The name is displayed on the ScreenLogic Connect dialog as shown below:

Check this box to save the current login information

Pentair Brick (192.168.2.2.:80) is the existing ScreenLogic Protocol Adapter IP address.

Do not configure this adapter.

ScreenLogic Video & Lighting

Protocol Adapter name

ScreenLogic Video & Lighting Protocol Adapter User’s and Installation Guide