7
5.Select the camera manufacture and model and click the OK button.
Note: Only configure one camera at a time. For example, connect the first camera, then configure it. Plug in the second camera and repeat.
6.Select the installed video camera model to rename the camera and set its IP address. The cameras IP address must be in the same subnet range as your ScreenLogic Video & Lighting Protocol Adapter. The default IP address for the ScreenLogic Video & Lighting Protocol Adapter is 192.168.2.3 - It is recommended that you select a higher IP address to avoid conflict on your network. For example, use
192.168.2.80 for camera No. 1, 192.168.2.81 for camera No. 2, etc.
7.For additional cameras, click the Add New Camera button and repeat steps 1 - 6.
8.Click Done when finished. The Configuration setup dialog box will be displayed.
ScreenLogic Video & Lighting Protocol Adapter User’s and Installation Guide