Magma 7 Slot Series user manual Installation Guide, Step One Install 64-Bit HostInterface

M A G M A

Chapter 2 Installation Guide

The following steps will guide you in completing the installation of your new 64-bit/66MHz 7 Slot PCI Expansion System.

Electrostatic Discharge (ESD) Warning

All PCI cards are susceptible to electrostatic discharge. When moving PCI cards, it is best to carry the cards in anti-static packaging. If you need to set a PCI card down, be sure to place it inside or on top of an anti-static surface. For more information, see “Protecting Against Electrostatic Discharge”.

WARNING

High voltages are present inside the expansion system when the unit’s power cord is plugged into an electrical outlet. Disconnect the power cord from its source before removing the enclosure cover. Turning the system power off at the power on/off switch does not remove power to components. High voltage is still present.

CAUTION

Before touching anything inside the enclosure, move to an ESD station and follow proper ESD procedure. Failure to do so may result in electrostatic discharge damaging the computer or its components. For more information, see “Protecting Against Electrostatic Discharge”.

Step One: Install 64-Bit HostInterface

Power down your host computer system.

Use the procedures for shutting down your system provided in your owner's manual or system documentation. Turn off power to your computer.

Remove the cover.

Install the 64-Bit Host Interface in any available PCI slot in your host computer and secure with a retaining screw.

The 64-bit/66MHz PCI Host Interface Card is a standard "short" universal PCI adapter card. Install it in your host computer by inserting

4 Chapter 2 Installation Guide