Magma PE6RR, PE6R4, PCI Expansion System manual RechecktheInstallation

M A G M A

Connect cables to	Connect cables to
the chassis.	the host card.

When properly installed, each cable will have matching labels at both ends (x1 to x1 and x3 to x3).

CAUTION

All cables attached to the expansion chassis must be securely fastened. When you hear a “click,” it is properly secured. If not securely connected, the connectors may cause intermittent or lost connections.

Connect the power cord to the power-in receptacle located at the rear of the enclosure.

NOTE

If at all possible, plug all power cords from the expansion chassis and your host computer into a shared power strip, preferably one that has surge and noise suppression circuitry built into it.

RechecktheInstallation

Check your installation before powering up the Magma expansion chassis for the first time. Although the power supply has an over voltage protection device built into it, it may not "trip" in time to fully protect a device that has been improperly connected, or whose power cable has been damaged.

CAUTION

This product is provided with a power supply that automatically adjusts to input voltages between 100 to 240 Vac. A U.S. and Canadian 125 V power supply cord is provided with this product. If using this product outside of the U.S. or Canada, please use locally available power supply cords

6Chapter 2 Hardware Installation