M A G M A
If your rack has holes too large for the screws, you can use the Bar Nut to secure your mounting by inserting the Panhead screw through the rack hole and screwing it into the Bar Nut on the reverse side of the rack post, as shown:
NOTE
Notice that the holes on the Bar Nut are spaced unevenly to accommodate different racks.
The EB2 chassis requires two extender brackets (supplied with the
The extender brackets should be attached
Extender bracket
Attach Slide Rail to Rack
Attach the other side of the rack with “fingers” pointing “out” and the end bracket to the rear. Secure each Slide Mount with 4 screws as shown below.
Secure the slide rail to the rack with 2 screws to both front and rear posts. After you have secured the slide rail fingers to the rack posts, tighten the 2 screws used to attach the slide rail to the end bracket.
16