M A G M A
Make sure that all PCIe cards are fully seated in their connectors. When correctly seated in its connector, you will notice a firm resistance when you pull up gently on the card. To keep the cards in place, secure them in the enclosure with their retaining screws (supplied with the Magma expansion chassis).
If your PCIe card is too short for the adjustable card slot guides, you can rotate the slot guard to make if fit. Simply loosen the adjustment screw for the slot you are using
and slide the guard to pivot hole, as shown, and remove it. Next, rotate the slot guard 180° and reinsert it. Finally, adjust the card slot guard to fit
the card’s length.
IMPORTANT
The sheer number of PCIe cards and device drivers available makes it impossible for Magma to fully test and certify all available PCIe cards for use in the Magma expansion chassis. Our best advice to you in this regard is to insist on full PCI Express Specification compliance from your card and system vendors. Cards and systems should be at least compliant with PCIe revision
1.0or better. Compliance in your system motherboard, PCIe cards, and console firmware (or BIOS) is your best assurance that everything will install and operate smoothly.
26