Danish Interpretation Systems | User Manual |
Operating instructions
PS 6000 Power Supply
General description
The PS 6000 Power Supply provides additional Power for the DCS 6000 system.
One CU 6005/6010 Central Unit is needed in each DCS 6000 system; however for expansion of the system the PS 6000 Power Supply is suitable. The PS 6000 consists of:
∙One Power Supply
∙Control electronic for detecting system power
Features
The main features of the PS 6000 Power Supply are:
∙Built in Power Supply for app 60 units (Delegates) or app. 150 Channel Selectors
∙One connector for connection to Delegate Units, Interpreter Units etc.
∙One connector for connection previous unit (i.e. CU 6005/6010.
∙Delayed switching on of power to minimise the total
∙Designed in a small size
Connectors
The PS 6000 Power Supply features the following connectors:
Power connector
Connection for main power.
Loop through connectors
RJ45 connector, 2 pieces
Power LED
Those green LED light up when Power is available on the connector next to the LED.
System design
There are no settings to be done on the PS 6000 Power Supply.
However it is important to observe, that the unit is only adding power to one of the chains on the CU 6005/6010 Central Unit.
And as so, the specification, which applies the two chain outputs on the CU 6005 Central Unit and to each of the chain outputs on the CU 6010 Central Unit, does also apply to the output on the PS 6000.
And the PS 6000 is NOT a repeater, which means that the maximum cable length in a chain (which without repeater is 200 m) has to be calculated from the last unit with repeater functionality (typically a CU 6005/6010, EX 6010 or RP 6004) to the last unit connected to the PS 6000.
This includes interconnection cables between the units.
Manual 01 18 04450 | 7 |
|