Linak MJB user manual Environmental conditions, Precaution

Page 16

Warning!

The systems must not be sprayed directly with a high-pressure cleaner.

Warning!

Interconnecting cables must remain plugged in during cleaning to prevent the ingress of water.

Precaution!

When cleaned, water must never be sprayed upwards from underneath the bed, because it may enter the cable outlet.

Environmental conditions:

Environmental conditions

 

 

 

Operating:

 

 

 

Temperature

5°C to 40°C

Relative humidity

20% to 90% @ 30°C – not condensing

Atmospheric pressure

700 to 1060 hPa

 

 

Storage:

 

 

 

Temperature

-10°C to +50°C

Relative humidity

20% to 90% @ 30°C – not condensing

Atmospheric pressure

700 to 1060 hPa

 

 

Valid where nothing otherwise is stated under the specific products in a later section.

16

Image 16
Contents MJB Gateway Page Contents Preface Important information Safety instructionsDescription of the various signs used in this manual Residual risk Before installation, re-installation, or troubleshooting Information on the MJBBefore start-up During operationDisposal of LINAK’s products RepairsComponent Recycling group Maintenance Warranty and service lifeMisc. on the MJB system MJB Gateway variant, 504-01 Standard functionalityOptions special article FeaturesUsage Example of closed loop RelayExample of Open Loop Precautions Cable ordering nos. Modular plug open end IP Protection degree IP Protection Cleaning instrucionsFollowing disinfectants/detergents are recommended Environmental conditions PrecautionEnvironmental conditions Modular plug with wide slit Modular plug with narrow slitKey to symbols ETL LGA Drawing Appendix MJB Modular Junction BoxLinak Application Policy Page Page Factories