MEMS Interface Card
QUICK START GUIDE
Rev 4 | December 2013 |
This guide provides the basic information needed to set up and use your new NovAtel® MEMS Interface Card (MIC). For more detailed information on the installation and operation of your MIC, download the SPAN on OEM6 User Manual from our web site at www.novatel.com.
BOX CONTENTS
In addition to this Quick Start Guide, the following is provided with your MIC:
•1 MIC to IMU interface cable
•1 IMU mounting PCB (printed circuit board)
(a PCB is not included with the
•Screws and standoffs for mounting the MIC
ADDITIONAL EQUIPMENT REQUIRED
The additional equipment listed below is required for a typical setup:
•An OEM615 receiver
The MIC supports all OEM6® family receiver cards for communications. The OEM615 is the only OEM6 family receiver card that can be directly integrated and powered by the MIC.
•An IMU (see the IMU Type column in Table 1, CONNECTIMU Commands on page 9)
•A
If the MIC is installed in a standalone configuration, a separate power supply is required for the OEM6 family receiver. For information about the power supply requirements, refer to the Technical Specification appendix for the receiver card in the OEM6 Family Installation and Operation User Manual. This user manual is available from our website at www.novatel.com.
•A wiring harness to provide power to the P101 connector on the MIC
•A wiring harness to connect the customers equipment to the P301 connector on the MIC.
•A quality,
•An antenna cable
•A Windows® based computer
1