Novatel GM-14915118 quick start Skip to Install the PC Utilities on

Page 5

Ensure all standoffs are properly installed and the mounting location for the receiver is level.

The amount of board deflection (bow and twist) must not exceed 0.75%. For example, on the OEM615 which is 71 mm long and 46 mm wide, the deflection along the length must not exceed 0.53 mm and the deflection along the width must not exceed 0.34 mm.

4. Connect the antenna cable to the antenna jack (J101) on the OEM615.

The antenna cable must have a right angle MCX connector on the end that connects to the OEM615.

Do not apply power to the cards until the antenna cable is attached.

The part number for the recommended MCX connector is M1051-110 (ShinA Telecom). If an alternate is used part, it

should meet the dimensions shown in the diagram.

The space between the OEM615 and the MIC is limited. The height of the MCX connector must not exceed 8.65 mm.

5. Align the OEM615 mating connector (J301) on the MIC with the 20-pin header (P1101) on the OEM615. Make sure all of the pins on the header are aligned with the holes in the mating connector.

Press down on the MIC to seat the connector on the header.

6. Use the four screws supplied with MIC to secure the MIC to the OEM615.

7. Connect the IMU-to-MIC interface cable to the IMU.

8. Connect the IMU-to-MIC interface cable to the IMU connector on the MIC.

• Use the 10-pin locking connector (P701) for the ADIS IMU.

• Use the 20-pin locking connector (P601) for the HG1700, HG1900, HG1930 or STIM300 IMU.

9. Using a customer supplied wiring harness, connect a +10 to +30 V DC power supply to the power connector (P101) on the MIC. This connection provides power to the MIC and the OEM615.

See the SPAN on OEM6 User Manual for pin out information for the power connector.

10. Using a customer supplied wiring harness, connect the communications connector (P301) to the user system.

In a stack up configuration, the P301 connector provides connections for the: MIC serial port, OEM615 serial port (COM2), USB port, Event1 trigger, Event2 trigger, 1 Pulse Per Second (PPS) output, Variable Frequency (VARF) output, Reset Input and Position Valid output.

See the SPAN on OEM6 User Manual for pin out information for the communications connector.

All signal I/O with the exception of the USB port are at LVTTL levels.

To connect the MIC to devices that use other signals levels, such as a computer with an RS-232 serial port, an interface circuit that converts to and from LVTTL must be used.

Use a twisted pair for the USB port connection and keep the wires as short as possible.

11.Skip to Install the PC Utilities on page 8.

5

Image 5
Contents Additional Equipment Required BOX ContentsMIC to OEM-IMU-ADIS-16488 OEM Cable Kit IMU SetupsMIC Install the MIC in a Stack UP ConfigurationASP-163577-01 Skip to Install the PC Utilities on  OEM628 Recommendations Install the MIC in a Standalone ConfigurationPage Establishing a New Receiver Connection Install the PC UtilitiesConnectimu Commands Configure the Span SystemLOG Span Data Ascii Operate the Span SystemQuestions or Comments POST-PROCESS Data