Quantum Audio PX502 quick start Introduction, Notational Conventions

PX502 Tape Library

Quick Start Guide

TABLE OF CONTENTS
Introduction	1
Notational Conventions	1
Choosing a Location	2
Rack Space Requirements	2
Environmental Conditions	2
Preparing for the Installation	2
Providing Necessary Tools	2
Taking ESD Precautions	2
Unpacking the PX502 Tape Library ...	2
Installing the Library	3
Locating the Mounting Position ....	3
Installing the Library	4
Initial Configuration	11
Multiple Library Stacks	15

Introduction

The PX502 tape library is an automated storage and retrieval device consisting of up to two tape drives and up to 32 SDLT cartridges or 38 LTO tape cartridges (see figure 1).

Notational Conventions

This instruction uses the following conventions:

NOTE: Notes emphasize important information related to the main topic.

CAUTION: Cautions indicate potential hazards to equipment and are included to prevent damage to equipment.

WARNING: Warnings indicate potential hazards to personal safety and are included to prevent injury.

This document explains how to unpack the PX502 tape library and install it in a standard 19 in. rack. Once the library is unpacked and installed, set up the library using the instructions in the PX500 Series User’s Guide PN 81-81290. This installation procedure will take approximately 4 hours to complete.

NOTE: It is recommended to review the entire document prior to beginning the installation.

Figure 1 PX502 Tape Library