Quantum Audio PX502 quick start Rack Depth Back Mounting, Clamp, Mounting Position Holes

PX502 Tape Library Quick Start Guide

Table 4 Back Mounting Bracket

Orientation

Back mounting bracket

#1 Holes

#2 Holes

Back mounting clamp

Rack Depth	Back Mounting	Back Mounting
	Bracket	Clamp
	(Mounting
	Position)	#1	#2
		Holes	Holes
24 to 25 in.	Back bracket and	N/A	N/A
	clamp not required
25 to 26 in.	Back bracket and	N/A	N/A
	clamp not required
26 to 27 in.	Back bracket and	N/A	N/A
	clamp not required
27 to 28 in.	Use holes A and C	X
28 to 29 in.	Use holes B and D	X
29 to 30 in.	Use holes C and E	X
30 to 31 in.	Use holes D and F	X
31 to 32 in.	Use holes E and G	X
32 to 33 in.	Use holes F and H	X
33 to 34 in.	Use holes G and I	X
34.5 to 35.5 in.	Use holes F and H		X
35.5 to 36.5 in.	Use holes G and I		X

Once the location is determined, attach the back brackets to each side of the library with four M5 x 8 Allen screws (see figure 10).

NOTE: If your rack has a depth less than 27 in., the back brackets and back clamps are not used.

Figure 10 Installing the Back

Mounting Brackets

Back mounting bracket

M5 x 8 Allen screws

Right-hand back bracket shown.

NOTE: If this is a multiple stack configuration, refer to “Multiple Library Stacks” on page 15 for information on preparing the library chassis for passing tape cartridges from one unit to another.

2Install the library into the rack as shown in figure 11 and secure the library to the rack with four PHILLIPS screws.

WARNING: The PX502 tape library weighs approximately 52 lbs (23.6 kg). At least two people are required to lift and install the library.

Figure 11 Installing the PX502 in

the Rack

PHILLIPS screws

9