If the “SNZ” button is pressed, the alarm will silence for approximately 5 minutes, after which it will begin to sound again.
The alarm uses 3 different patterns of tone, beginning gently and increasing in intensity, known as a "Crescendo Alarm".
Battery Replacement Information
To replace the battery:
1.Lift up the battery compartment cover and remove the battery.
2.Please take note to install the battery with the proper polarity as it relates to the battery diagram inside the battery compartment (+). The battery will fit tightly. To avoid
3.Replace compartment cover.
Help us to keep our environment clean. Please take any used batteries to an authorized depot for recycling.
Mounting the Unit
The clock can be set on a table or mounted onto a wall.
Table Standing
An easel type foldout stand is located on the bottom of the back side of the clock. Pull the easel out from the bottom to open it.
Wall Mounting
Select a place to mount the clock. Install a mounting screw (not included). Align the hanging hole to the mounting screw and ensure that the clock locks down into place before releasing it.
Online Resources
Visit the
http://www.lacrossetechnology.com/8002
Care and Maintenance
Extreme temperatures, vibration and shock should be avoided as these may cause damage to the unit and give inaccurate readings.
Precautions shall be taken when handling batteries. Injuries, burns, or property damage may be resulted if batteries are in contact with conducting materials, heat, corrosive materials or explosives. Batteries should be taken out of the unit before it is stored for a long period of time.
Immediately remove all low power batteries to avoid leakage and damage. Replace only with new batteries of the recommended type.
When cleaning the display and casings, use a soft damp cloth only. Do not use solvents or scouring agents as they may mark the LCD and casings.
Do not submerge the unit in water. Furthermore, fix all parts in place where the units are adequately protected against moisture and rain.
Special care shall be taken when handling a damaged LCD display. The liquid crystals can be harmful to user's health.
Do not make any repair attempts to the unit. Contact the La Crosse Technology® Warranty Department for help. Opening and tampering with the unit may invalidate their guarantee.
Never touch the exposed electronic circuit of the device as there is a danger of electric shock should it become exposed.
Do not expose the units to extreme and sudden temperature changes, as this may lead to reduce their accuracy.
Troubleshooting
Battery:
Battery problems are the single largest cause of customer support cases. A few things to check:
∙Use a fresh battery
Please use a plain Alkaline battery that tests no less than 1.48 on a voltmeter or with an expiration date that is 7 years in the future.
∙Ensure correct polarity
Ensure that the clock has a fresh battery and is installed using correct polarity as shown inside the battery compartment (+).
Warranty Information
La Crosse Technology, Ltd provides a
This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd’s authorized service center.
La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new
Page 5 of 8 | Page 6 of 8 |