The Minutes digits of the Alarm Time will flash. Use the “PLUS” button to set the minutes. You can hold the "PLUS" button in to speed up the setting of minutes by using five minute increments. Press the "ALARM" button to confirm your minutes setting and to end the setting procedure.
4.To activate or deactivate the daily alarm: Briefly press the “ALARM” button once. When the alarm is active the clock displays the alarm icon 
below the word "TIME", when the alarm is deactivated, the alarm icon 
will not display.
5.About the Time Alarm:
After 15 seconds without pressing any button the clock switches automatically from alarm setting mode to normal clock mode.
The alarm will sound for 85 seconds if not deactivated. You can deactivate it by pressing any button. The alarm will be repeated automatically after 24 hours.
The alarm uses 3 different patterns of tone, beginning gently and increasing in intensity, known as a "Crescendo Alarm".
Battery Replacement Information
Wireless Display
To replace the batteries in the wireless display:
1.Lift up the battery compartment cover and remove the batteries.
2.Please take note to install the batteries with the proper polarity as it relates to the battery diagram inside the battery compartment (+). The batteries will fit tightly. To avoid
3.Replace compartment cover.
Please follow the steps listed in the Setup section of this manual to ensure that the wireless data reception is successful.
The
The
Help us to keep our environment clean. Please take any used batteries to an authorized depot for recycling.
Page 7 of 12