Quick SET-UP Guide

Battery

Cover

Place the screw partially

a second per day. These physicists have created an international standard, measuring a second as 9,192,631,770 vibrations of a Cesium-133 atom in a vacuum.

1.Insert two AAA batteries into the Remote Control Sender.

2.Insert two AA batteries into the WEATHER STATION.

3.Wait 5 minutes, or until the outdoor temperature is displayed in the OUTDOOR LCD (Liquid Crystal Display).

4.Wait 6-10 minutes (in ideal reception conditions) for the WWVB time to be displayed in the TIME LCD. If the WWVB takes longer to set, you may manually set the time (see complete instructions), or you can wait until after the weather station conducts its programmed search at the ideal reception time period of 12:00am to 6:00am.

5.Mount the units, ensuring that all units are sending and receiving signals.

Note: The Remote Control Sender transmits a signal every 3 minutes; after the batteries have been installed, the Weather Station will search for the signal for a duration of 5 minutes. If there is no temperature reading in the OUTDOOR LCD after 5 minutes, make sure the units are within range of each other, or repeat the battery installation procedure.

DETAILED SET-UP GUIDE

I. BATTERY INSTALLATION

A. REMOTE CONTROL SENDER

1.Remove the mounting bracket. The bracket snaps on and off easily.

2.Remove the battery cover, by

removing the Flathead screw located on the backside of the unit, in the lower-central position. The rubber weather-seal creates a tight seal for the battery cover, and does not allow the battery cover to fall away from the unit.