IV) COMPLETE RESETTING OF PRECIPITATION DATA
Note: The rain data held by the bar chart and other rain totals (excluding the
1)Enter the Rain Multiplicator mode as instructed in steps 1 through 3 of the Manual Reset of the Rain Multiplicator section above.
2)After setting the rain multiplicator, while the left digit is flashing, press the RAIN/SET button for 8 seconds. This will clear data, and reset it to 0.
V)RECEPTION REQUIRMENTS
The Rain Monitor receives data from the Rainfall Transmitter every 5 minutes, while the Rainfall Transmitter transmits data every 1 minute. Data is transmitted immediately after rain has been detected. If 3 transmission attempts are made and no data is received,
A)RESETTING
1)Remove batteries from the Rain Monitor and Rain Gauge.
2)Wait 30 seconds, or
3)Follow Programming instruction.
The Rain Monitor cannot receive data in the Programming Mode, nor during the numeric display of the bar chart. Reception is also interupted when a button is pressed, and will continue when the button is released.
The transmission range is approximately 80 feet (25m) in open space. The surrounding environment and interference levels influence this transmission range.
VI) ICONS
A)FLASHING RAIN CLOUD
A flashing rain cloud appears in the upper right hand corner of the LCD screen, when the Rainfall Transmitter is accumulating rain and transmitting data.
B)SATELLITE ICON
The satellite icon appears above the right column of the bar graph, when the Rain Monitor is searching for a signal from the Rainfall Transmitter.
9