La Crosse Technology WS-7038U Detailed SET-UP Guide Battery Installation, Rainfall Transmitter

Page 4

DETAILED SET-UP GUIDE

I)BATTERY INSTALLATION

Note: Batteries will fit tightly. To avoid start-up problems make sure that the batteries do not spring free.

Battery compartment

Battery cover

A) RAINFALL TRANSMITTER

1. Remove the flat-head screw and battery cover, located on the underside of the base.

2.Observe the correct polarity, and install two AA batteries.

3.Make sure the rubber weather seal is in place and replace

the battery cover and screw.

4. Separate the base by turning the rainfall collector in a counter-clockwise direction. Remove the tape from the teeter-totter. Replace the cover.

Teeter- Totter

B. RAIN MONITOR

1.Remove the battery cover on the backside of the unit.

2.Observe the correct polarity, and install 2 AAA batteries.

3.Replace the battery cover.

Note: After the batteries have

been installed, the entire LCD (Liquid Crystal Display) will light up briefly, then the default settings will be initiated.

Battery Compartment

Battery Cover

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents WS-7038U Wireless 433 MHz Miniature Rain Monitor Table of Contents Inventory of Contents Quick SET-UP GuideRainfall Transmitter Detailed SET-UP Guide Battery InstallationRain Monitor Program Mode II Time SettingIII Date Setting Function ButtonsRain Alarm Setting IV Weekday SettingVI Resetting the Total Rain Amount Features & Operations BAR Graph III Manual Reset of the Rain Multiplicator II Numerical Representation of the BAR GraphIV Complete Resetting of Precipitation Data ResettingReception Requirments VI Icons Flashing Rain CloudMounting TX5U-RAINFALL Transmitter II the Wireless Rain Monitor Using the TABLE-STANDMaintenance & Care Wall MountingTroubleshooting Specifications Data Check IntervalsWarranty Information Support@lacrossetechnology.com
Top Page Image Contents