Ultra electronic M9006-654E, M9007-224E, M9007-225E, M9006-644E Installing the UltraDriver

Page 6

www.ultramagicard.com

AVALON and AVALON DUO Printer USER MANUAL

2.Installing the UltraDriver

1.Important - Make sure the printer is switched off.

2.Load the driver CD ROM into the PC you have connected to the printer. If the CD does not run automatically, click the start button, then click on “run”. Type “D:\autorun” (where D is the drive letter for your CD drive), then press the return key.

The driver CD ‘Splash Screen’ will appear.

Select your printer model – Avalon or Avalon Duo.

3.Select the “Install Software” option

4.Then select the “Install Driver” option

The driver installation will begin and the driver installation window will open

5.Click ‘Next >’ on the ‘Available Platforms’ screen.

6.Click ‘Next >’ to start copying the driver files. Then wait while the USB driver files are installed and registered.

8.At the “Installation Successful” window – click ‘Finish’.

9.Make sure the printer is connected via the USB cable to your PC. Then switch ON the printer.

There will be a short delay while the printer initializes.

Then Windows will detect the printer via the USB connection and will complete the installation.

•It is recommended that you test the new driver installation by printing a Windows Test Page from the ‘General’ tab of the Printer Driver Properties – the Windows Logo should be printed in the centre of the card.

(To configure the new Printer Driver’s settings please see Section 8 – Printer Driver Settings – for a detailed explanation of each setting).

Page 6 of 31

Image 6

Contents Standard Option Avalon Duo Only Index Safety Instructions Before Use About this guide Unpacking Install the dye filmPrepare the cleaning cassette ConsumablesPrint a test card Installing the UltraDriver Click ‘Next ’ on the ‘Available Platforms’ screenChoosing the right Dye-Film Ribbon Loading the Dye-Film RibbonChoosing the right Cards Loading HoloPatch Cards Loading the CardsLoading Magnetic Stripe Cards Loading Infra-Red Barcode CardsCleaning your Printer To clean your printer, follow the three main steps belowUsing a cleaning card Cleaning Kits for Europe, Middle East, Africa & AsiaCleaning Kits for North and South America To clean the card feed mechanismChanging the cleaning roller To replace the cleaning rollerTo clean the printhead Printer Driver settings To access the Printer Driver SettingsPrinter Tab Magnetic Encoding Encode Only Printing Options Number of CopiesHand Feed Magnetic Encoding VerifyCard Front & Card Back Tabs Card Orientation Landscape/Portrait Security Print OvercoatHoloKote RotateBlack Resin Options Halftoning Monochrome Only All Black in image is printed withOvercoat Options Overcoat Area SelectionOvercoat Holes Advanced Tab Colour AdjustmentPrinthead Power Printhead & Image PositionsOvercoat Yellow, Magenta, Cyan YMCBlack Resin Image PositionSave Settings to File Save & Restore TabSave & Restore Settings Restore Settings from File Restore Defaults Restore Factory DefaultsUninstalling the UltraDriver To delete the UltraDriverThen select Add or Remove Programs Install the Magicard Support Utility from the Driver CD Magicard Support UtilityUpgrade Firmware Query PrinterEthernet Dye Film Problems Problem Probable CauseCard Feed Problems Magnetic Encoding ProblemsDriver Related Problems Warranty Limited Warranty InformationTechnical Support, Service, and Warranty Enquiries Call EU +44 0 1305 762Sales for Latin America Sales and Service Center for North and South AmericaContact Us Sales Sales for EuropeSales and Service for Russia Sales and Service for Singapore & MalaysiaCanadian Department of Communications Statement EMCFederal Communications Commission FCC Statement EU Declaration of Conformity