www.ultramagicard.com
AVALON and AVALON DUO Printer USER MANUAL
Step 2. Every 1000 Prints -
Changing the cleaning roller
There is a cleaning cassette inside the printer which holds a cleaning roller (picture 1). We recommend that this roller is replaced after every 1000 prints, or sooner if it looks dirty.
You
To replace the cleaning roller: | 2 |
•Switch off your printer.
•Open the top cover. Locate the black cleaning cassette towards the rear of the internal compartment.
•To remove the cleaning cassette, hold it between thumb and forefinger by the tab on the top of the cassette (picture 2). Push down lightly on it, and then lift it out.
•You now have the cassette and roller assembly out of the printer. This is a two roller assembly. The bottom roller is permanent and the top (larger) roller is disposable (picture 3).
•Remove the used roller from the cassette (picture 4).
•Take a new roller and remove the protective white cover from around the roller.
•Insert the new roller into the cassette, ensuring that the roller is ‘sprung’ in the cassette.
•Insert the cassette back into the printer ensuring it is seated correctly.
1
3
4
Step 3. Cleaning the Printhead
You should clean the printhead if any lines are seen on printed cards.
To clean the printhead:
•Use the special printhead cleaning pen from your Magicard printer cleaning kit. See ‘Cleaning Supplies’.
•Open the printer and draw the pen several times across the length of the printhead.
Page 12 of 31