Step 4: View LEDs/Adjust Mounting
LEDs are located in the cable compartment.
When the unit is powered on, the
The following table shows the status of the LEDs when the
Status | Power | Wireless Link | Ethernet Link |
|
|
|
|
Starting up | Three red blinks | N/A | N/A |
| followed by a |
|
|
| temporary solid |
|
|
| amber |
|
|
|
|
|
|
Radio scanning | Blinking green | N/A | N/A |
|
|
|
|
WORP link is up | Solid green | N/A | N/A |
|
|
|
|
No WORP link | Blinking amber/ | N/A | N/A |
| green |
|
|
|
|
|
|
System failure | Solid red | N/A | N/A |
|
|
|
|
No traffic on | N/A | Solid green | Solid green |
interface |
|
|
|
|
|
|
|
Normal operation | Solid green | Blinking green | Blinking green |
/ passing traffic |
|
|
|
|
|
|
|
Bootloader mode | Permanent solid | N/A | N/A |
| amber |
|
|
|
|
|
|
If a wireless link is not established with the BSU, adjust the direction of the unit so that the integrated antenna is more precisely aimed toward the BSU. When the Power LED is solid green, the link is correctly established.
Page 12 | Copyright © 2006 Proxim Wireless |