Printronix T5000e setup guide Rfid PGL Commands, Write Tag, Format

Chapter 3 RFID PGL Commands

RFID PGL Commands

Write Tag

Purpose To program non-incremental data into an RFID tag (embedded in the smart label).

MODE CREATE

Format

RFWRITE;[HEX;][EPCm;][RFn;L;][LOCK;]ATp;[(D)datafield(D)]

RFWRITE;	The RFID Write Tag command.
HEX;	Optional parameter to indicate that the
	text in datafield is in hexadecimal format
	and that it will be converted to binary
	format.
EPCm;	Optional parameter to indicate that the
	data in datafield should be converted to
	an EPC number. When this parameter is
	used, the HEX option is automatically
	enabled and the data field is limited to a
	maximum of 14 digits. The AT parameter
	is ignored. The tag is then programmed
	as follows:
	Bits 0 to 1 are programmed with the
	EPC value 0 to 3, specified in m.
	Bits 2 to 57 are programmed with the
	hexadecimal characters in the data field
	(14 maximum). If the data field has less
	than 14 hexadecimal characters, zeros
	are assumed for the remaining digits.
	Bits 58 to 63 are set to zero.
RFn;L;	Optional parameter to indicate that this
	field has dynamic data. Replace n with a
	number ranging from 1 to 512 to identify
	the field number of this RFWRITE field.
	Replace L with the length of the dynamic
	data string. If this option is used, the

56