Telenetics MIU56 manual Modem AT Commands, Dial Modifiers

Page 12

Industrial Modem MIU56 User Guide

Modem AT Commands

Your Industrial Modem has a number of specific commands that control and enhance its operation. To access and change these commands open a local terminal connection with your modem using your preferred communications software, such as WinFax Pro, and type the letters AT followed by the specific command and press <Enter>. The AT commands are case insensitive and may be entered in either lower or capital letters.

„indicates the default settings

Commands

 

Command

Description

A

Answer call

D

Dial number

H

Hang up modem

O

Enter On-line state

Dial Modifiers

 

Dial Digits

0-9, A, B, C, D, #, *

,Pause while dialling

F or ^

Disable calling tones

JInitiate MNP 10 at 1200 bps (V.22)

KMNP 10 cellular power level adjustment for this call

LRedial last number

MInitiate MNP 10 at 4800 bps (V.32)

P

Pulse dial number

R

Switch to answer mode

S=n

Dial stored number ÔnÕ (where n=0-9)

T

Tone dial number

W

Wait for dial tone

;Return to Local command state

!Hook flash

@Wait for quiet answer

MIU56Robert Way

Page 12

2/28/2003

Image 12
Contents MIU56 Table of Contents Industrial Modem MIU56 User Guide Legal & Regulatory Information Copyright InformationIntroduction Modem Controls and Indicators Links Internal controlsPstn OUTModem Features Power Down FeatureDial and Talk Feature How to Load the Voice Alarm Messages Voice Messaging SystemAT#MEM1 AT#MEM2Remote Voice Setting of Alarm Messages Asynchronous Mode Synchronous ModeOperating Modes Line SpeedsLeased Line Operation Modem AT Commands CommandsDial Modifiers General Commands Speaker on during dial, answer, retrain or rate change #MEM0 #MEM1#MEM2 #MINIDisable welcome message Modulation Setting Mod Modulation Possible Rates bpsDistinctive Ring AT-SDR=0AT-SDR=7 Response Codes Registers AsciiSpecifications Data Compression EncryptionEnvironmental Humidity