Industrial Modem MIU56 User Guide
&F1 |
| Restore |
&F. |
| Reset modem (clear security database/Telephone numbers) |
&G0 | | No guard tone generated |
&G1 |
| 550 Hz guard tone generated |
&G2 |
| 1800 Hz guard tone generated |
&K0 |
| Flow control disabled |
&K3 |
| RTS/CTS flow control |
&K4 |
| XON/XOFF flow control |
&K5 |
| Transparent XON/XOFF flow control |
&K9 | | Failsafe flow control |
&M0 | | Asynchronous mode |
&N0 |
| Abort dial character disabled |
&N1 | | Abort dial character enabled |
&P0 |
| 39/61 make/break ratio (USA) |
&P1 | | 33/67 make/break ratio (Aus/UK) |
&S0 |
| DSR signal always asserted |
&S1 | | DSR signal asserted at start of handshake |
&S2 |
| DSR signal asserted at end of handshake (before CONNECT message) |
&T0 |
| Terminate current test |
&T1 |
| Local Analogue Loopback test |
&T3 |
| Local Digital Loopback test |
&T4 | | Grant Remote Digital Loopback test |
&T5 |
| Deny Remote Digital Loopback test |
&T6 |
| Remote Digital Loopback test |
&T7 |
| Remote Digital Loopback with |
&T8 |
| Local Analog Loopback with |
&V |
| View active configuration profile |
&Vn |
| View stored profile |
&V8 |
| View differences between active and default |
&Wn |
| Save current configuration into stored profile n (n=0,1,2,3) |
&Yn |
| Select stored profile n for Power on and &D3 |
&Zn=x |
| Store x as phone number n |
#A0 |
| Prevent Remote Access |
#A1 |
| Allow remote access |
#A2 | | Allow remote access with security password |
#ALMn=x |
| Dial number/s x |
#B0 | | In 1200bps originate mode B0=V.23, B2=V.22 |
#B1 |
| In 1200bps originate mode B0=V.22, B2=V.23 |
#C0 |
| V.25 calling tones disabled |
#C1 | | V.25 calling tones enabled |
#J0 |
| Assume V.42 compatibility |
#J1 | | Check V.42 compatibility |
#K0 |
| Disable MNP 10 |
#K1 | | Enable MNP 10 |
#K2 |
| Enable MNP 10 for Cellular links |
#MEM0 |
| All voice features off |
#MEM1 | | Voice mode after S110 rings if DTR is low |
#MEM2 |
| Voice mode after S110 rings regardless of DTR |
#MINI |
| Erase Voice mode alarm message |
#M0 | | AT command operation |
#O0 | | Characters ignored if modem buffers overflow |
MIU56Robert Way | Page 15 | 2/28/2003 |