SSI
ERP2U Power Supply Design Guide, V2.31
4Mechanical Overview
STATUS
Required (Optional)
The ERP2U is a power sub-system made up of a cage and redundant, hot swappable power supply modules. A mechanical drawing of the cage is shown below in Figure 1. Two depths are defined to the cage; 400mm and 350mm. This cage is intended to be mounted in the system and not redundant or hot swappable. The exterior face of the cage accepts hot swappable power supply modules. The cage distributes output power from the modules to a wire harness. Cooling fans, EMI filtering, and IEC inlet connector(s) may be located in the modules or cage.
.0 +/- 1.0 | | | 30 MAX |
400400. / 350.0 +/-1.0 | | |
SIDE VIEW | | | HANDLE/LATCH |
| | |
#6-32 THD | | 118.0 +/- 1.0 | #6-32 THD |
4 PLACES | | 113.0 +/- 0.5 | 2 PLACES |
| | |
| | | 15.0 +/- 0.5 |
6.0 +/- 0.5 | | MODULE | |
| 83.0 +/- 0.5 | 61.8 +/- 0.5 |
| ACCESS |
6.0 +/- 0.5 | |
| | 56.8 +/- 1.0 |
| | |
| | 108.0 +/- 0.5 | |
Figure 1: Enclosure Drawing
- 9 -