SOYO SY-6BA+ IV user manual Reset, Speaker, Turbo LED

Hardware Installation SY-6BA+ IV

2.Reset

Plug the Reset push-button cable into the 2-pin Reset header on the Motherboard. Pushing the Reset button on the front panel will cause the system to restart the boot-up sequence.

Reset Pin Assignment

1

Power Good

3.Speaker

GND

Attach the 4-pin PC speaker cable from the case to the Speaker header on

the Motherboard.

Speaker Pin Assignment

+ _

+5V NC NC Speaker out

4.Turbo LED

Connecting the 2-pin Turbo LED cable to the corresponding Turbo LED header will cause the LED to light whenever the system is in Turbo mode. The manufacturer has permanently set this Motherboard in Turbo mode due to most hardware and software compliance to turbo mode.

Turbo LED Pin Assignment

+ _

LED Cathode GND

32