SOYO SY-6BA+ III manual ATX Power, GND Ø Pay special care to the directionality

Hardware Setup SY-6BA+ III

Warning: Follow these precautions to preserve your

Motherboard from any remnant currents when connecting

to ATX power supply:

Turn off the power supply and unplug the power cord

of the ATX power supply before connecting to ATX PW

connector.

The Motherboard requires a power supply with at least 200 Watts and a "power good" signal. Make sure the ATX power supply can take at least 720 mA * load on the 5V Standby lead (5VSB) to meet the standard ATX specification.

*Note: If you use the Wake-On-LAN (WOL) function, make sure the ATX power supply can support at least 720 mA on the 5V Standby lead (5VSB).

Please install the ATX power according to the following pin assignment:

ATX Power

12V

5VSB PW-OK GND 5 V GND 5 V GND 3.3V

3.3V

5V

5V

-5V

GND Ø Pay special care to the directionality.

GND

GND

PS-ON

GND

-12V 3.3V

20