SOYO SY-6BA+ III Onboard Parallel Ports Setting Description, Parallel Port Mode, ECP Mode use

BIOS Setup Utility SY-6BA+ III

3-8.5 Onboard Parallel Ports

Onboard Parallel Ports

Onboard Parallel Port

Setting	Description	Note
378H/IRQ7	Choose the printer I/O	Default
3BCH/IRQ7	address.
278H/IRQ5

Parallel Port Mode

ECP/EPP

SPP

ECP

EPP/SPP

The mode depends on Default your external device that connects to this port.

If [Parallel Port Mode] is set to [ECP] mode

ECP Mode use

DMA

3	Choose DMA3	Default
1	Choose DMA1

If [Parallel Port Mode] is set to [EPP] mode

EPP Mode Select

PWRON After PWR-Fail

EPP 1.9	Select EPP port type 1.9
EPP 1.7	Select EPP port type 1.7	Default
On	The system will switch on
	when power comes back
	after a power failure.
Off	The system will remain	Default
	off when power comes
	back after a power
	failure.
Former-sts	The system will return to
	the state it was in before
	the power failure when

power returns. (i.e: If the system was on, it will switch on again, if it was off, it will remain off)

60