The SOYO CD
|
| SOYO | |
|
|
|
|
|
| and to assign a port address. | |
|
|
|
|
| ParallelPortAddress | Use this item to enable or disable the onboard Parallel port, | |
|
| and to assign a port address. | |
|
|
|
|
| ParallelPortMode | Use this item to set the parallel port mode. You can select | |
|
| SPP (Standard Parallel Port), ECP (Extended Capabilities | |
|
| Port), EPP (Enhanced Parallel Port), or ECP + EPP. | |
|
|
|
|
| ECPModeDMA | Use this item to assign a DMA channel to the parallel port. | |
| Channel |
|
|
| ParallelPortIRQ | Use this item to assign IRQ to the parallel port. |
|
|
|
|
|
| OnboardPCI/IDE | Use this item to enable or disable either or both of the | |
| Controller | onboard Primary and Secondary IDE channels. | |
| Use this item to enable or disable the onboard IDE channel. |
| |
|
|
|
|
| AudioDevice | This item enables or disables the AC’97 audio chip. | |
|
|
|
|
| ModemDevice | This item enables or disables the MC’97 modem chip. | |
|
|
|
|
| EthernetDevice | This item enables or disables the onboard Ethernet LAN. | |
|
|
|
|
| OnboardUSB | Enable this item if you plan to use the USB ports on this | |
| Function | motherboard. | |
| USBFunctionFor | Enable this item if you plan to use the USB ports on this |
|
| DOS | motherboard in a DOS environment. |
|
3.7 Power Management Setup Page
This page sets some parameters for system power management operation.
PowerManagementSetup
ACPIAwareO/S | Yes |
PowerManagement | Enabled |
Suspendmode | S1 |
SuspendTimeOut | Disabled |
ResumeOnRTCAlarm | Disabled |
LAN/RingPowerOn | Disabled |
KeyboardPowerOn | Disabled |
AnyKey | |
|
|
↑↓←→ :Move | Enter:Select |
F1:GeneralHelpF9:OptimizedDefaults
HelpItem
Enable/Disable
ACPIsupportforOperatingSystem.
Enable:IfOSsupportsACPI.
Disable:IfOSdoesnotsupportACPI.
| ACPIAwareO/S | This item supports ACPI (Advanced Configuration and |
|
|
| Power management Interface). Use this item to enable or |
|
|
| disable the ACPI feature. |
|
| PowerManagement | Use this item to enable or disable a power management |
|
|
| scheme. If you enable power management, you can use the |
|
|
| items below to set the power management operation. Both |
|
|
| APM and ACPI are supported. |
|
|
|
|
|
|
| 22 |
|