SOYO SY-K7VTA PRO user manual IDE HDD Block Mode, FDD Controls, Onboard Serial Ports

BIOS Setup UtilitySY-K7VTA PRO

3-5.3 IDE HDD Block Mode

	Setting	Description	Note
Disabled
	IDE HDD Block Mode
	Enabled	Invokes multi-sector	Default
		transfer instead of one
		sector per transfer. Not
		all HDDs support this
		function.

3-5.4 FDD Controls

FDD Controls	Setting	Description	Note
Onboard FDD
	Disabled	Turn off the on-board
controller		floppy controller
	Enabled	Use the on-board floppy	Default
		controller

3-5.5 Onboard Serial Ports

Onboard Serial	Setting	Description	Note
Ports

Onboard

Serial Port 1 /

Serial Port 2

Disabled

3F8/IRQ4	Choose serial port 1 & 2's I/O	Default
	address.	(port 1)
2F8/IRQ3	Do not set port 1 & 2 to the	Default
	same address except for	(port 2)
3E8/IRQ4	Disabled or Auto.

2E8/IRQ3

Auto

UART 2 Mode

Standard

HPSIR

ASKIR

The second serial port offers Default these InfraRed interface modes.

If [UART Mode Select] is set to [IrDA]/[ASKIR]

IR Function Duplex

Half	Choose [Half] or [Duplex] to	Default
Full	set UR2 in half duplex mode
	or full duplex mode
	respectively. Refer to your IR
	device specifications to select
	the suitable mode.

71