SnapGear warranty ¾ Common VPN Scenarios, SnapGear to SnapGear VPN IPSec

Page 7

Check Obtain an IP address automatically, check Obtain DNS server address automatically and click OK (in 95/98/Me, reboot the PC if prompted to do so).

You are now finished.

¾Common VPN Scenarios

Generally there are two common scenarios in which you will want to set up your SnapGear appliance(s):

LAN-to-LAN:Linking two branch offices across the Internet. For this case we recommend using IPSec. The SnapGear VPN can operate with both static and dynamic public (Internet) IP addresses.

For the example below we assume SnapGear appliances are installed at either end, and both have a static public IP address, or one is static and one is dynamic. The example tunnel will be using pre-shared keys for authentication, aggressive mode for keying, and be established going out through the default gateway interface. Proceed to SnapGear to SnapGear VPN (IPSec).

Please refer to the IPSec section of the User Manual if you are trying to set up something more complex, and for a detailed description of all available options.

Roaming: Connecting to your SnapGear appliance, installed at your home or office, from a single PC at a remote location. For this case we recommend using PPTP because the client is standard in Windows and other operating systems, and it is quite simple to set up. Proceed to Remote Workstation to SnapGear VPN (PPTP).

SnapGear to SnapGear VPN (IPSec)

Perform these steps for either end of the connection. Unless instructed otherwise, leave all options at their default settings.

STEP 1

Enable IPSec

Select IPSec from the VPN menu.

Underneath IPSec General Settings select This SnapGear has a static IP address IPSec endpoint, or This SnapGear has a dynamic IP address IPSec endpoint as appropriate. This is referring to the public (Internet) IP address of this SnapGear appliance. Check with your ISP if unsure.

Check Enable IPSec, and click Apply.

13

14

Image 7
Contents Quick Install Guide Unpack the SnapGear appliance Set up a PC to connect to the SnapGear Management Console192.168.0.1 Select Use the following DNS server addresses and enter DefaultRoot Page LAN with a Dhcp server Set up the PCs on your LAN to access the InternetLAN with no Dhcp server Select Dhcp Server from the Networking menu SnapGear to SnapGear VPN IPSec ¾ Common VPN ScenariosAdd a New IPSec Connection Local Endpoint SettingsRemote Endpoint Settings Phase 1 SettingsVerify Phase 2 SettingsEnable Pptp Server Remote Workstation to SnapGear VPN PptpAdd User Accounts Configure Remote ClientStandard Warranty ¾ Terms and Conditions SnapGear WarrantyLimitation of Liability Extended Four Year WarrantyReturn Procedure Technical SupportSnapgear END User License Agreement Australia USA