SmartBridges sB3410 manual Snmp Security

i n t e l l i g e n t w i r e l e s s p l a t f o r m

The following page summarizes the page contents of the System Configuration page.

	Table 7-1 System Configuration Page Items
Page Item	Descriptions.
System Name	Displays name of airClient unit
	Allows user to change airClient unit name
System Description	Displays description of airClient unit
	Allows user to change airClient unit description
SNMP Security	Access the SNMP security settings
Reset	Reset device
Reset To Factory	Reset device to factory defaults
Defaults
Delayed Reset	Schedule a reset
NTP Server	NTP server setup, as well as NTP time if server is setup
Software Version	Display the installed firmware version
Radio Firmware	Display the installed radio firmware version
Version
Edit Configuration	Provide links to edit IP, radio, configurations
Ethernet MTU Size	Set the Ethernet MTU Size
Syslog server IP	Display the current message Syslog server IP Address.
Address	User can change the IP address.
SNMP Trap IP	Display the current SNMP trap IP address.
	User can change the IP address.
Log Level	Display the current Log Level
	Suspends/Enables the radio defenders.
	If the Watch Guard is Suspended the defenders will stop for 2 hours and start
	again thereafter.
Watch Guard	If the Watch Guard is enabled the radio defender’s will start immediately.
	Note: The Radio Defenders will monitor the Wireless Association Status
	(automatically) and traffic and take corrective action if needed.
LED Control	Display the current led on status.
	User can change the LED status to on/off
Current	Display the current operational mode.
Operational mode	User can change the current operational mode.

7.1.1. SNMP Security

The user can edit the SNMP Community String and SNMP Access filters. The SNMP community needs to match with the SNMP monitoring software used. The SNMP Access Filters allows you to determine which host(s) is authorized to monitor the device using SNMP. It is recommended that you set this for security reason and to prevent an attack. To change the SNMP security settings, click on the SNMP security link in the System Configuration page. Figure 7-2 shows the SNMP Security Configuration page.

airClient™ Nexus User Guide Page 49 of 66