SmartBridges sB3410 manual airClient Router Ethernet Configuration

Page 28

i n t e l l i g e n t

w i r e l e s s

p l a t f o r m

1.From the ’Summary Information’ page, click on the ’Ethernet Configuration’ link to change Ethernet parameters.

2.Enter the ‘IP address’ and ‘IP mask’.

3.Click on ‘Apply Changes’ to effect the changes.

Figure 2-14 airClient Router Ethernet Configuration

2.8.2. Wireless Configuration

The wireless parameters need to be configured to allow the airClient Router unit to associate with an airPoint™ or any third party access point.

Follow these steps below to configure the airClient Router/NAT Mode Wireless IP Settings parameters:

1.Click on the ‘Wireless Configuration’ link from the ‘Summary Information’ page.

2.Enter the wireless ‘IP address’, ‘IP Mask’, ‘Gateway IP’ address for the airClient unit.

3.Check the ‘Enable DHCP’ checkbox if the IP address can be obtained automatically from the wireless link.

4.Click on the ‘Apply Changes’ to change the settings.

airClient™ Nexus User Guide

Page 28 of 66

 

Image 28
Contents AirClient Nexus SB3410 VersionTable of Contents T e l l i g e n t w i r e l e s s A t f o r m Overview of User Guide About This DocumentRelated Publications Technical Support Center Introduction System RequirementsChecklists Pre-Installation Checklist for airClientParameters Units Site a Site B Signature of Engineer Name DatePost-Installation Checklist for airClient RssiChecklist Parameters Units Site a Site B AirClient Configuration User Login and License AgreementLicense Agreement Web GUI Administrator Password Change Using the Configuration Pages Description of Menus Menu Item Menu Sub-itemsMenu Item Menu Sub-items Description NetworkingSaved profiles and shows last Help Device Mode Configuration Device mode settings same for Router/NAT modeAirClient Bridge to airClient Router/NAT Changing airClient Bridge to airClient Router/NATAirClient Router/NAT to airClient Bridge Changing airClient Router/NAT to airClient BridgeEthernet Configuration AirClient Bridge ConfigurationWireless Configuration 10 airClient Bridge Wireless Settings Bridge Configuration 11 Link StatusConfiguring Spanning Tree Protocol STP 12 Bridge Configuration InformationSTP Settings Configuration Setting Default Value Range Purpose Radio port Radio aAirClient Router/NAT Configuration 13 Bridge Configuration14 airClient Router Ethernet Configuration 15 airClient Router Wireless IP Configuration 16 airClient Router Wireless Association Settings Dhcp Configurations 18 Dhcp Server ConfigurationsDhcp Relay Configurations 19 Disable Dhcp and Dhcp Relay20 Dhcp Relay Agent Configurations Routing Table22 Adding Static Route Wireless Settings Management Wireless SettingsData Encryption Valid Key Key Table24 Data Encryption Disable Link Performance Parameters and Features Performance Parameters and Bandwidth ControllerThroughput OptimizerBandwidth Controller AirClient Bandwidth ControllerSite Survey Tool Site Survey showing associated devicesAntenna Alignment Antenna AlignmentT e l l i g e n t R e l e s s A t f o r m Traffic Statistics Ethernet Traffic StatisticsTransmitted Bytes Transmitted Unicast packetsWireless Traffic Statistics Transmit Success Rate Transmit Multiple retryTransmit Retry rate Transmitted Failure countWireless Traffic Statistics ACK Receives Failure CountRTS Fail No of Aborted FramesSystem Configuration ToolsSnmp Security Reset Options NTP Time Server Setup Delayed Reset SettingsNTP Time Settings Profile ManagerDescription of Commands Save ProfileLoad Operating Profile Profile CalendarScheduling a Profile Link Test Ping Test ResultLink Budget Planning Throughput Test ResultLink Budget Planning Calculator GPS Calculator 10 Link Budget Planning Calculator Link Budget Firmware Upgrade AirClient Nexus Firmware UpgradeAirClient Nexus Firmware Upgrade Firmware transferred Appendix a Snmp Trap Appendix B Useful terms and definitions Acronyms and AbbreviationsDhcp Snmp Appendix C License