Unitech Hand Held Scanner user manual Wand Emulation, Code 39 Output, Native Output

Page 14

Chapter 5 Wand Emulation

5.1Installation

Figure 4 shows how a wand emulation scanner is installed to a data collection terminal. User needs to pay attention to the scanner pinout that should be the same as specified by the terminal.

SCANNER

Figure 4. Installed as a Wand Emulation Scanner

5.2Understanding the Operating Parameters

Code 39 Output:

When device number “07” is selected, the scanner is set as wand emulation with Code 39 output. In this configuration, the scanner always outputs data with Code 39 symbology no matter what symbology of the label it scans. You may scan the following label if this setting matched your application.

Code39 Wand

Emulation

Native Output:

When device number “26” is selected, the scanner is set to wand emulation with native output. That means the scanner outputs data with both the same contents and symbology as the label represents.

Page 13

Image 14

Contents User’s Manual RS232 Serial Interface PIN Assignment and Specification Chapter Overview Keyboard Interface InstallationInstallation procedures Installed on PC/AT without keyboard or laptop computer Installed on MacintoshInterblock Delay Installed as an USB InterfaceIntercharacter Delay Understanding the Operating ParametersCaps-Lock Alt Key ModeFunction Code Installed as a Serial Interface RS232 Serial InterfaceHandshaking Device TypeBaud Rate, Parity and Data Bit Time Out Serial TTLBCC Character Installing as a Terminal Wedge Terminal InterfaceData Direction Native Output Wand EmulationCode 39 Output Polarity of Idle Appendix D Output of Wand Emulation Appendix DLevel Duration of Minimum Width Appendix D Setup Procedures Chapter SetupBar Code Menu Setup Bar Code Length Setting Code ID SettingPreamblePrefix and PostambleSuffix Predefined LabelsQuick Setup Batch SetupI800C06D51DJ8 08080A0O7C005354 I800C06D51DJ8080 80A0O7C005354415254 Formula Output Data EditingGeneral InputIDLengthMatchA-StringO-String...O-String Enter ProgrammingProgramming Sequence PreparationProgramming Sheet Parameter EntryQualifier Input ID FormatLength Match FormatModifier String FormatExample Advanced FeaturesExamples Example Pin Assignments Pin Assignment and SpecificationPin Number Signal Keyboard InterfaceTTL RS232 Interface PinNumber Standard RS232 InterfaceHost Side connector Terminal InterfaceWand Emulation Terminal Side connectorPin Number Signal Specification A.1 A.2 Device ID Device Type Appendix D. Setup MenuDevice Selection and Default Beeps and Delays MPU Idle StatusKeyboard Wedge Settings RS232 Settings Scanner Port Define Code IDMagnetic Reader Code 39 / I 2 of 5 / S 2 of 5 / Code 32 / EAN128 ReserveCode 128 / MSI Code / Code 93 / Codabar/ Label Code MSI /Pleasey CodeUPC / EAN / Delta Code UPC-EData Editing Dump Setup Strings Appendix E. Full Ascii Chart E.1E.2 E.3 E.4 Appendix F. Bar Code Test Chart