Unitech Hand Held Scanner user manual Terminal Side connector, Wand Emulation, Pin Number Signal

Page 33

Terminal Side connector

The connector for the terminal is a DB25 male and has following pinout:

1	13
14	25
DB25 Male (Front View)
Pin	Signal
Number
2	RXD
3	TXD
4	CTS
5	RTS
6	DTR
7	GND
8	CD
20	DSR

8.1.4.Wand Emulation

The pinout on modular connector at the bottom of the scanner is:

Pin Number	Signal
1	Not Used
2	VCC(+5V, output)
3	Not Used
4	GND
5	Not Used
6	Bar Code Output
7	Power Input(+5V±5%) DC
8	Not Used
9	Not Used
10	Not Used

Page 32

Image 33

Contents User’s Manual RS232 Serial Interface PIN Assignment and Specification Chapter Overview Installation Installation proceduresKeyboard Interface Installed on Macintosh Installed on PC/AT without keyboard or laptop computerIntercharacter Delay Installed as an USB InterfaceInterblock Delay Understanding the Operating ParametersAlt Key Mode Function CodeCaps-Lock RS232 Serial Interface Installed as a Serial InterfaceDevice Type Baud Rate, Parity and Data BitHandshaking Serial TTL BCC CharacterTime Out Terminal Interface Installing as a Terminal WedgeData Direction Wand Emulation Code 39 OutputNative Output Output of Wand Emulation Appendix D Level Duration of Minimum Width Appendix DPolarity of Idle Appendix D Chapter Setup Bar Code Menu SetupSetup Procedures Code ID Setting Bar Code Length SettingPredefined Labels PreamblePrefix and PostambleSuffixBatch Setup Quick SetupI800C06D51DJ8 08080A0O7C005354 I800C06D51DJ8080 80A0O7C005354415254 Output Data Editing GeneralFormula Programming Sequence ProgrammingInputIDLengthMatchA-StringO-String...O-String Enter PreparationParameter Entry Programming SheetInput ID Format QualifierMatch Format LengthString Format ModifierAdvanced Features ExamplesExample Example Pin Number Signal Pin Assignment and SpecificationPin Assignments Keyboard InterfaceNumber PinTTL RS232 Interface Standard RS232 InterfaceTerminal Interface Host Side connectorTerminal Side connector Pin Number SignalWand Emulation Specification A.1 A.2 Appendix D. Setup Menu Device Selection and DefaultDevice ID Device Type MPU Idle Status Beeps and DelaysKeyboard Wedge Settings RS232 Settings Define Code ID Scanner PortMagnetic Reader Reserve Code 39 / I 2 of 5 / S 2 of 5 / Code 32 / EAN128MSI /Pleasey Code Code 128 / MSI Code / Code 93 / Codabar/ Label CodeUPC-E UPC / EAN / Delta CodeData Editing Dump Setup Strings E.1 Appendix E. Full Ascii ChartE.2 E.3 E.4 Appendix F. Bar Code Test Chart