Unitech Hand Held Scanner user manual Specification

Page 34

On the other end of the wand emulation cable is a squeeze released DB9 female connector. The pinout for this connector is:

Pin Number	Signal
1	Not Used
2	Bar Code Output
3	Not Used
4	Not Used
5	Not Used
6	Not Used
7	GND
8	Not Used
9	Power Input

8.2 Specification

* Power:
- Operating Voltage:	+5V ±5% DC.
* Temperature:
- Operating:	0°C to 50°C (32°F to 122°F)
- Storage:	-20°C to 70°C (-4°F to 158°F)

*Humidity:

-0% to 95% relative humidity.

Page 33

Image 34

Contents User’s Manual RS232 Serial Interface PIN Assignment and Specification Chapter Overview Installation procedures InstallationKeyboard Interface Installed on PC/AT without keyboard or laptop computer Installed on MacintoshInterblock Delay Installed as an USB InterfaceIntercharacter Delay Understanding the Operating ParametersFunction Code Alt Key ModeCaps-Lock Installed as a Serial Interface RS232 Serial InterfaceBaud Rate, Parity and Data Bit Device TypeHandshaking BCC Character Serial TTLTime Out Installing as a Terminal Wedge Terminal InterfaceData Direction Code 39 Output Wand EmulationNative Output Level Duration of Minimum Width Appendix D Output of Wand Emulation Appendix DPolarity of Idle Appendix D Bar Code Menu Setup Chapter SetupSetup Procedures Bar Code Length Setting Code ID SettingPreamblePrefix and PostambleSuffix Predefined LabelsQuick Setup Batch SetupI800C06D51DJ8 08080A0O7C005354 I800C06D51DJ8080 80A0O7C005354415254 General Output Data EditingFormula InputIDLengthMatchA-StringO-String...O-String Enter ProgrammingProgramming Sequence PreparationProgramming Sheet Parameter EntryQualifier Input ID FormatLength Match FormatModifier String FormatExamples Advanced FeaturesExample Example Pin Assignments Pin Assignment and SpecificationPin Number Signal Keyboard InterfaceTTL RS232 Interface PinNumber Standard RS232 InterfaceHost Side connector Terminal InterfacePin Number Signal Terminal Side connectorWand Emulation Specification A.1 A.2 Device Selection and Default Appendix D. Setup MenuDevice ID Device Type Beeps and Delays MPU Idle StatusKeyboard Wedge Settings RS232 Settings Scanner Port Define Code IDMagnetic Reader Code 39 / I 2 of 5 / S 2 of 5 / Code 32 / EAN128 ReserveCode 128 / MSI Code / Code 93 / Codabar/ Label Code MSI /Pleasey CodeUPC / EAN / Delta Code UPC-EData Editing Dump Setup Strings Appendix E. Full Ascii Chart E.1E.2 E.3 E.4 Appendix F. Bar Code Test Chart