UB334 Paper OM reduced size.fm Page 30 Friday, September 9, 2005 11:16 AM
direction upward. 
or 
appears according to the current search direction.
Storing Frequencies Found During Chain Search into Channel Memory
You can store frequencies you find in chain search mode or chain search hold mode.
1.Press Func + Pgm in chain search mode or chain search hold mode. The lowest blank channel appears.
2.Press E/Pgm to store the frequency into the blank channel. To select another channel, press Func + 
or Func + 
before you press E/Pgm.
If you try to save a frequency that is already stored, the scanner sounds an error tone and displays the channel that was duplicated. If you entered the frequency by mistake, press 
/Clr. To enter the frequency anyway, press E to accept.
The scanner sets itself to program mode after you store a frequency.
Setting the Search Range
You can use this mode to define the search range used during a search in each search bank. To change a search range, press Func and PSrc. SRCH appears. Then select a search bank.
When you select the search bank, the lower limit and upper limit frequency assigned in the search bank alternate on the display.
To select another search bank, press Func + PSrc or Func + 
to increase the search bank number or Func + 
to decrease it. Hold down Func + 
or
Special Features
30